Acqua Brevetti PuliMATIC Manual De Instrucciones Para El Uso Y El Mantenimientomanual De Montaje E Instalación página 46

damages to the plastic parts. If the system is subject to water hammering, install an appropriate
damping system. If the water pressure can exceed the maximum operating pressure of the filter
even for short periods, install a protective pressure reducer.
Avoid overhead installation in order to prevent damages to property or persons in the
event of a fall, a collapse or water leakages.
B1.5 Electrical checks after installation
After connecting the filter to the power supply, the display will automatically turn on; the filter
reaches the filtration stage and the display switches off.
After this stage, check the operation of the circuit by manually pressing the buttons
simultaneously, until the motor starts; the filter performs a washing procedure. Check the correct
functioning of the backwash solenoid valve, if installed (optional). The solenoid valve is in closed
position during the washing operations performed by the filter and in open position during filter
operation.
B1.6 Hydraulic checks after installation
After having opened the water upstream of the equipment:
1. Check for any leaks;
2. Check that the appliance is correctly positioned so as to ease ordinary maintenance
operations.
3. Check that the system is equipped with: disconnector, by-pass, sampling taps
4. Verify that there are no leaks from the inlet and outlet fittings and from the filter drain.
5. Check the compliance of the system with any local regulations or recommendations issued
by the competent local offices
If in doubt, contact Acqua Brevetti SRL (tel. +39.049.8973432, e-mail: [email protected]).
B1.7 Allowed assembly diagrams
It is essential to install the filter respecting the water flow direction; water is fed from the
left connection while water output takes place from the right connection, keeping the
filter with the front logo facing you. In case you want the filter to be configured with
water feeding from the right side and water output from the left side, this configuration
has to be requested upon order. Any other configuration may result in the incorrect
operation of the equipment.
The filter drain connection must be conveyed into a visible drain in a stable manner.
In case of doubt,
[email protected]).
B1.8 Installation of the washing solenoid valve (optional)
The closing solenoid valve must be installed on the filter outlet connection (see item 8 of the
example B of the installation diagrams).
To manage the closing solenoid valve, the control panel is required (see item 9 of the example B of
the installation diagrams). The manufacturer makes available the optional control panel (code
23022030).
PuliMATIC - ENGLISH
contact Acqua Brevetti
MAN141 PAGE E-20
SRL (tel.: +39.049.8973432 or e-mail: