A1.7 Characteristics of the water to be treated
PuliMATIC has been designed and built for treating water intended for human consumption.
PuliMATIC is not designed to filter closed circuit water, water containing large quantities
of sand or coarse bodies larger than 2 mm, silt or chemicals (oils, solvents, acids,
bases, glycols).
For applications other than the ones expressly described herein, it is necessary to contact Acqua
Brevetti SRL (telephone: +39.049.8973432, e-mail:
[email protected]) before performing the
installation.
A1.8 Precautions for use
PuliMATIC is a piece of equipment connected to 220 Volt power supply. The plug has
to be inserted into a standard socket, provided with a ground contact and protected by a
residual current circuit breaker. Check that the plug is firmly inserted into the socket and
located in a protected area, away from accidental contact, water splashes, humidity and
heat sources. To perform any intervention, disconnect the filter from the power supply.
A1.9 Power supply connection
Connect the power supply terminals in the housing of the filter and close the rear casing. Insert the
power supply directly into a 230 V socket.
When the filter is switched on, if it is not in the correct position, it rotates to position itself in the
filtration position.
In the event of a power failure, the filter retains the last programmed setting when it is switched on
again.
PuliMATIC - ENGLISH
MAN141 PAGE E-5