Corghi MONSTER AGTT Manual De Uso página 62

E05 Not used
E10
E11 No signal on digital channel #1
(chain ring counting proximity
switch)
Table 2 – Errors and actions to be performed
Normally the numbers or messages shown on the display are fixed, but they may flash
in some cases�
As a general rule, which is valid for all operating modes, the following applies:
when the numbers and/or messages flash, this means that the displayed value must be
confirmed by the operator or that an operator action is required�
ACOUSTIC SIGNALS
In all operating modes, the display emits the acoustic signals specified in table 3:
Acoustic signal
1 short bip
2 short bips
1 short bip +
1 long bip
3 short bips
Slow continuous flashing
Table 3 – Acoustic signals
62
Meaning
Button pressed
confirmation for
- memory setting/deleting
- inch/mm selection
Not used
Confirmation�
The action was completed
successfully�
Failed�
The action was not
completed successfully
or the requested action is
not permitted�
Special operating mode
active�
Operator's manual MONSTER AGTT
Check the connection of the prox-
imity switch and its condition�
Action
None�
None�
None�
Repeat the action after
changing the machine
parameter being used
or perform a permitted
action�
Used in SETUP MODE
(for example for
calibration) to call
attention to the fact that
a special, potentially
dangerous operating
mode is active�