Mowing Duration; Adjusting The Cutting Height - Stihl RMI 632 P Manual De Instrucciones

English
the mower is in operation. Never allow the robotic mower to
operate if you know that animals or persons are or may be
in the mowing area or vicinity.
When automatic mowing is switched on, the robotic mower
independently leaves the docking station and mows the lawn
during the active times set by the operator, @ 14.6. The
number and duration of the mowing and charging operations
within the active times are determined automatically.
The mowing plan is determined based on the size of the
mowing area calculated during installation or during the
creation of a new mowing plan.
When you switch on automatic mowing, the display
shows the automatic mowing symbol next to the
battery symbol.
► Define starting points in linked areas to have the robotic
mower automatically mow linked areas.
► To end an active mowing operation manually, press the
STOP button on the robotic mower or press the ON/OFF/
Home button on the docking station twice at any time.
When the battery is discharged, the robotic mower
automatically returns to the docking station.

16.2 Mowing Duration

The mowing duration specifies how many hours per week
the robotic mower will mow the lawn. Charging time is not
included in the mowing duration.
During initial installation, the robotic mower automatically
calculates the mowing duration appropriate for your lawn
based on the specified size of the mowing area. The
calculation is based on a normal lawn under dry conditions.
To complete a mowing area of approximately 1076 sq. ft.
(100 m²), the robotic mower will need approximately 60
minutes on average.
► If necessary, extend or reduce the active times and
mowing duration, @ 14.6 and @ 14.7.
58

16.3 Adjusting the Cutting Height

WARNING
To reduce the risk of serious personal injury or death,
always press and hold the STOP button for 5 seconds to
activate the disabling device before adjusting the cutting
height of the mowing blade.
A
2
1
To lower the cutting height (A):
► Press and turn the rotary knob (1) counterclockwise.
The marking (2) indicates the selected cutting height.
To raise the cutting height (B):
► Press and turn the rotary knob (1) clockwise.
The marking (2) indicates the selected cutting height.
8 different cutting heights can be selected:
– Level 1: 0.79 in. (20 mm)
– Level 2: 1.01 in. (25.7 mm)
– Level 3: 1.24 in. (31.4 mm)
– Level 4: 1.46 in. (37.1 mm)
– Level 5: 1.69 in. (42.8 mm)
– Level 6: 1.91 in. (48.5 mm)
– Level 7: 2.13 in. (54.2 mm)
– Level 8: 2.4 in. (60 mm)
16 During Operation
B
2
1
0478-131-3046-A