Waeco MagicWatch MWE250 Instrucciones De Montaje página 37

MWE-250-3.book Seite 37 Dienstag, 28. März 2006 4:50 16
MagicWatch MWE250
6.5 Installing the speaker on the boot cover
The piezoelectronic speaker should be glued to or mounted on a suitable
place on the boot cover.
Note the following information when selecting the installation location for the
piezoelectronic speaker:
Note the length of the cable for the piezoelectronic speaker.
Note that the boot cover swings upwards on vehicles that have a big tail-
gate.
The piezoelectronic speaker must not be covered or damaged by any
objects placed on the boot cover.
You can set the volume to either off (Off), low (Lo), or loud (Hi), using the
switch on the front of the speaker.
➤ Insert the socket of the piezoelectronic speaker into the socket of the
extension cable (see fig. 16 A, page 8).
➤ Guide the extension cable to the control electronics and insert the socket
of the extension cable into the connection on the control electronics (see
fig. 16 B, page 8).
➤ Remove the protective foil and affix the speaker ...
➤ Or attach it using suitable screws.
6.6 Connecting the control electronics
Caution!
Make sure the polarity is correct.
On some vehicles, the reversing light only works when the ignition
is switched on. In this case, you must switch on the ignition in
order to identify the positive and negative wires.
➤ Connect the red cable (fig. 17.2, page 8) on the control electronics to the
positive wire (+) of the reversing light (fig. 17.1, page 8).
➤ Connect the black cable (fig. 17.3, page 8) to the earth wire (–) of the
reversing light or to earth (bodywork).
Installing MagicWatch
37