SFS isoweld 3000 Instrucciones De Operación página 36

Ocultar thumbs Ver también para isoweld 3000:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Push the tab on the orange shell down into the frame (left). Now that the
generator is installed, the shell can be relocated onto the studs (right).
Lift the shell up and onto the stud then push the shell ono the stud (left). It is
easiest to start with the top 2 studs then proceed to the bottom ones. Make
sure the routing of the power cord on the right side is correct so the orange shell
seats against the frame without pushing it out.
Finally, position the grey shell over the generator and install the 4 T20 screws.
That completes the generator swap procedure.
36

Capítulos

Tabla de contenido
loading

Productos relacionados para SFS isoweld 3000

Este manual también es adecuado para:

Isoweld backpack

Tabla de contenido