Start-up isoweld
The induction welding tool is delivered ready for operation ex-works.
After opening the container, remove the poles and hand-held inductor, then the
backpack unit can be carefully lifted out. The inductor unit, pole and cords can be
carefully assembled and attached to the tool.
1
3
4
18
Backpack
®
1. For use in stand-up mode, connect the handle
adaptor to the hand inductor.
2. Screw the adjustable handle into the top of
the handle adaptor.
3. Adjust the pole with the turning lock clamp to
an ergonomic working height.
4. Open the cover to the hand-held port and
connect the hand-held inductor.
4a. If desired, connect wired activation
5. Connect the tool to a suitable power source.
- the cable should not be too long
2
- suitable conductor cross section
- unroll extension cable (diagram page 19)
Ensure that the connection is correctly
made.
4a
switch.