SFS isoweld 3000 Instrucciones De Operación página 29

Ocultar thumbs Ver también para isoweld 3000:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

If there is damage or wear to any of the connection points, contact SFS tool
service or an authorized repair shop.
WARNING!
Using a tool with damaged straps or connection points may result in a
strap or connection breaking while in use and the machine may fall causing
personal injury.
Instructions for isoweld
Parts needed:
Description
isoweld
®
3000 tool
Replacement Generator
6 to 4 pin adaptor harness
Tools needed:
• T20 TORX
• bit driver extension (included)
• screw gun or bit driver
• small flathead screwdriver
* If applicable: 5 mm hex drive bit (to remove old style temp sensor)
Step 1: Grey shell removal
Before starting ensure the tool is not plugged in. It's helpful to lean the tool
forward and prop it up on something to make it easier to get access to the
generator. Now use the supplied T20 bit and extension to remove the 4 screws
holding the grey shell on (left). Once the screws are removed, pull the grey shell
straight off toward you. Now the generator can be accessed for removal (right).
®
3000 generator hot swap
®
bit (included)
Quantity
1
1
1
29

Capítulos

Tabla de contenido
loading

Productos relacionados para SFS isoweld 3000

Este manual también es adecuado para:

Isoweld backpack

Tabla de contenido