Operating Instructions - Wilo Stratos GIGA Serie Instrucciones De Instalación Y Funcionamiento

English
Access disable menu
8.6

Operating instructions

8.6.1 Adjusting the setpoint
Fig. 33: Entering the setpoint
8.6.2 Changing to menu mode
ON
1
Fig. 34: Standard menu mode
ON
1
Fig. 35: Service menu mode
Fig. 36: Error case menu mode
34
1.0.0.0
12.3
2200
RPM
1.0.0.0
1800
RPM
2 s
±
2.0.0.0
12.3
2 s
±
5.0.0.0
12.3
±
6.0.0.0
E000
The main menu <7.0.0.0> is only displayed when DIP switch 2 is in the
ON position. It cannot be reached via normal navigation.
In the "Access disable" menu, the access disable can be activated or
deactivated by turning the red button. The change is confirmed by
pressing the red button.
On the status page of the display, the setpoint can be adjusted as fol-
lows (Fig. 33):
• Turn the red button.
The display changes to menu number <1.0.0.0>. The setpoint begins
to flash and is increased or decreased by continuing to turn.
• To confirm the change, press the red button.
The new setpoint will be accepted and the display will return to the
status page.
To change to menu mode, proceed as follows:
2 s
• While the display is showing the status page, press the red button for
two seconds (except in case of an error).
Standard behavior:
The display changes to menu mode. Menu number <2.0.0.0> is dis-
played (Fig. 34).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first. (Fig. 35).
Error case:
In case of error, menu number <6.0.0.0> is displayed (Fig. 36).
WILO SE 01/2014