Preparations At The Workplace - Hilti TE 40 Manual Del Usuario

Chiseling (a )
h,Cheq
Uncertainty (K)
5 Operation

5.1 Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.2 Adjusting the depth gauge
1. Press the release button on the side handle.
2. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
4. Check that the side handle is securely attached.
5.1.3 Removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
To change the chuck, set the function selector switch to this position
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of chuck and pull the chuck release collar upwards.
3. Lift the chuck upwards away from the tool.
5.1.4 Fitting the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
Set the function selector switch to the
1. Disconnect the supply cord plug from the power outlet.
2. Grip over the end of the chuck and pull the chuck release collar upwards.
3. Fit the chuck onto the chuck mount.
4. Rotate the chuck until it engages in position.
Printed: 17.03.2017 | Doc-Nr: PUB / 5070952 / 000 / 02
TE 40
16.5 m/s²
1.5 m/s²
2
3
4
5
"Chiseling" position when changing the chuck.
TE 40­AVR
9.9 m/s²
1.5 m/s²
.
English 15