Hilti PP 10 Manual De Instrucciones página 27

7.10 Automatic alignment with the target plate 9
1. Set up the target plate with the reflective strips
facing the laser tool.
7.11 Display while searching 9
en The laser tool is not yet ready
for automatic alignment.
@
The display indicates stabiliz-
ation of the laser beam after
;
self-leveling.
The display indicates that
searching (auto centering)
=
is in progress.
Automatic alignment has
been completed.
%
Error during automatic align-
ment.
&
7.12 Selecting the laser beam mode
Press the laser beam mode button as often as necessary
until the desired display mode is shown in the display.
Constant beam
Blinking beam
High-power mode (only with the PP 25)
7.13 Adjusting the electronic bubble level 10
When the tool is pivoted, the bubble level appears clearly
in the display.
Adjust the tool until the "bubble" is in the center of the
display.
7.16 Target plate, front 12
Locking screw
@
Target plate, small
;
Bubble level
=
Target plate holder
%
7.17 Target plate, rear (2) 12
Reflective strip
&
7.18 Setting parameters
7.18.1 Setting units of measurement to % or ‰
1. Press the ON / OFF button and the LOCK button at
the same time.
The set values are shown in the display.
2. Use the laser beam UP / DOWN button to move to
the "unit" line.
3. Select the value you wish to change by pressing the
direction control button.
4. Press the SET button to confirm the entry.
The tool then returns to the normal operating mode.
22
2. Press the target plate auto-centering button.
NOTE This function may take up to 2 minutes before
starting.
The tool then searches for the target plate within its
alignment range (left/right).
The tool has not yet completed the self-leveling procedure.
NOTE This procedure will first be completed.
Please wait until this operation has been completed.
Searching (auto centering) then begins.
Check the position of the laser spot on the target plate.
NOTE If necessary, the remote control or the direction control buttons on
the tool (left / right) can be used to readjust the position of the beam.
If the beam loses contact with the target plate while searching, the pro-
cedure must be restarted.
The LED begins to blink as soon as the tool's compens-
ation range is exceeded.
7.14 Fitting the screw feet and centering screw 11
Fit the appropriate feet for the pipe diameter before
setting up the laser in the pipe.
NOTE
Feet are available in the sizes 150 mm, 200 mm, 250 mm
and 300 mm (6", 8", 10", 12").
7.15 Setting the target plate size 12
Set the target plate size to a value suitable for the pipe
diameter you are working with.
Secures the target plate at the desired height.
Target plate for 150 mm to 250 mm.
For setting up the target plate horizontally.
For automatic alignment.
7.18.2 Setting and activating the security code
Unauthorized persons can be prevented from using the
laser tool by entering a 4-digit security code. Please note
that once the security code has been activated, the laser
tool can no longer be operated without entering this code.
The code will be requested automatically after the tool is
switched on.
1. Press the ON / OFF button and the LOCK button at
the same time.
The set values are shown in the display.