Know Your Product; Operation; Prior To Initial Operation - SPARKY M 750 HD Instrucciones De Uso

the cut-off wheel from the cut while the
wheel is in motion otherwise kickback
may occur. Investigate and take corrective
action to eliminate the cause of wheel bind-
d) Do not restart the cutting operation in
the workpiece. Let the wheel reach full
speed and carefully re-enter the cut. The
wheel may bind, walk up or kickback if the
e) Support panels or any oversized work-
piece to minimize the risk of wheel
pinching and kickback. Large workpiec-
es tend to sag under their own weight.
Supports must be placed under the work-
piece near the line of cut and near the
edge of the workpiece on both sides of the
f) Use extra caution when making a "pock- et cut" into existing walls or other blind
areas. The protruding wheel may cut gas
Operations:
a) Do not use excessively oversized sand-
ing disc paper. Follow manufacturer's
recommendations,
sanding paper. Larger sanding paper ex-
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
Operations:
a) Do not allow any loose portion of the po-
lishing bonnet or its attachment strings
to spin freely. Tuck away or trim any
loose attachment strings. Loose and
spinning attachment strings can entangle
Brushing Operations:
a) Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration. Do not overstress the wires by ap-
bristles can easily penetrate light clothing
b) If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
EN
when selecting
diameter due to work load and centrifugal

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Spindle
2.1. Wheel guard for grinding wheel
2.2. Wheel guard for cutting wheel*
4.1. Grinding wheel (Use only with
a wheel guard for grinding wheel!)*
4.2. Cutting wheel (Use only with
a wheel guard for cutting wheel!)*
6. Auxiliary handle
8. Electronic regulator of rotation speed
(M 750E HD, M 850E HD)
9. Spindle lock button
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
10. Wire cup brush*
11. Plastic (rubber) backing pad*
12. Sandpaper or polishing bonnet*
13. Lock nut*
* The additional accessories shown in the illus-
trations or described in the text are not included
in the delivery.

Operation

These power tools are supplied from single-
phase alternating current mains only. They
are double insulated according to EN 60745,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is radio
suppressed in compliance with EMC Directive.
This power tool is designed for cutting, grinding
and brushing mainly metals without using wa-
ter.

PRIOR TO INITIAL OPERATION

guard mounted at the factory. Ensure that the
reliably prior to the initial and any following