Push Stick; Service And Maintenance; Accessories, Tools; Disposal - Festool PRECISIO CS 50 EBG Manual De Instrucciones Original

8.2b Angled cuts
- The mitre angle of the saw blade needs to be
adjusted for angled cuts, see section 7.2. The
preset profile setting rail is on the right-hand
side of the table.
- For mitre cuts, the preset profile setting rail has
to be adjusted, see section 7.5.
8.3

Push stick

- When not in use, the push stick [2-4] should be
placed in the accessory holder [2-1].
9

Service and maintenance

Always pull the mains plug before main-
taining, servicing or making any kind of
adjustment.
All maintenance and repair work which
requires the motor housing to be opened
must only be carried out by an authorised
service workshop.
Damaged safety devices and components
must be repaired or replaced in a recog-
nised specialist workshop in accordance
with regulations, unless otherwise indi-
cated in the operating manual.
Customer service and repairs: Only by
manufacturer or service workshops. Find
the nearest address at: www.festool.com/
service
Always use original Festool spare parts.
EKAT
4
Order no. at: www.festool.com/service
5
3
2
1
The machine is equipped with special self-dis-
connecting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
Maintain your machine regularly to make sure it
functions properly:
- Use an extractor to remove dust deposits,
- Keep guide rods [1-10] clean and grease them
regularly,
- Replace worn or damaged table inserts,
- Use the slide [11-1] to open the flap [11-3] in
order to remove offcuts from the lower guard.
To remove larger deposits, the flap can be com-
pletely opened by unscrewing the screw [11-2].
Close the flap again prior to use.
- After completing work, wind up the power cable
onto the accessory holder [2-1].
- A damper allows the saw unit to retract evenly
along the entire cutting length. If this is not the
case, the damper can be adjusted using the hole
[2-5].
- If it becomes necessary to replace the power
cable, this must be carried out by the manufac-
turer or the service team in order to ensure that
no hazards arise.
10

Accessories, tools

Festool provides comprehensive accessories
which allow you to use your machine effectively
and for diverse applications, e.g.: Extension ta-
bles (width and length), sliding table, trimming
attachment, dust extraction set.
In order to be able to saw different materials
quickly and cleanly, Festool offers saw blades that
are specially designed for your machine.
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
11

Disposal

Do not throw the power tool out in your house-
hold waste. Dispose of machines, accessories
and packaging at an environmentally responsi-
ble recycling centre. Observe the valid national
regulations.
EU only: In accordance with European Directive
2002/96/EC on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Information on REACh: www.festool.com/reach.
30