Setup; Safe Assembly; Assembling The Mast To The Base; Preparing The Lift For Use - Invacare Stand Assist Manual Del Usuario

Invacare® Stand Assist

3 Setup

3.1 Safe Assembly

WARNING!
Risk of Injury
Improper assembly may cause injury or damage.
– Assembly MUST be performed only by qualified
personnel.
– Use only Invacare parts in the assembly of
this patient lift. The lift components are
manufactured to specifications that assure
correct alignment of all parts for safe functional
operation.
– DO NOT overtighten the mounting hardware.
This will damage the mounting bracket.
There are no tools required to assemble the patient
lift.
If there are any issues or questions during assembly,
contact a local Invacare representative. Refer to the
contact information in the back of this manual.

3.2 Assembling the Mast to the Base

WARNING!
– Use only Invacare parts in the assembly of
this patient lift. The base legs, the mast,
boom, pump assembly and swivel bar are
manufactured to specifications that assure
correct alignment of all parts for safe functional
operation.
DETAIL A
DETAIL B
A Hex Bolt
B Washer
The mast assembly may be removed from the base
for storage or transporting. The mast assembly MUST
be properly secured to the base assembly before use.
1. Put the base on the floor.
Make sure all four casters make contact with the
floor.
2. Lock both rear casters Refer to Detail A.
8
C Nut
D Mounting Bracket
3. Remove the hex bolt, washers and nut that are located
in the U-shape cut-out of the base Refer to Detail B.
4. Lift the mast to an upright position.
5. Lower the mast onto the mounting bracket.
6. Attach the mast to the base with the hex bolt, washers
and nut. Tighten securely.

3.3 Preparing the Lift for Use

Check and tighten all hardware BEFORE use.

3.4 Installing the Shifter Handle

A Shifter Handle
1. Remove the shifter handle from the packaging carton.
2. Thread the shifter handle onto the male adapter on
the base.
3.5 Attaching the Battery Charger
Mounting Bracket to the Wall
Refer to your local regulations concerning proper
mounting procedures.
This procedure only applies to RPS350–1E models.
1. Place the battery charger with mounting bracket A on
the wall at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches (16.5 cm) from the pencil
mark and drill one mounting hole.
4. Install the bottom mounting screw C until there is an
approximate 1/8-inch (3 mm) gap between the screw
head and the wall.
5. Install the battery charger with mounting bracket onto
the bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws D through
the mounting bracket and into the wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
ON LED should illuminate.
B Male Adapter in Base
1078985-K