Tabla de contenido
cover and the countersunk head screw (fig. 4) are mounted. Both parts
are routed through the inner part of the outer socket and connected to the
lower part of the elbow component. The countersunk head screw must be
tightened with a torque of 5 Nm.
NOTICE
Risk of damage due to improper handling.
The MovolinoArm Friction 12K12 must not be flexed during charging and
use of the MyolinoLink 60X6.
4.3.2 Passive Prosthetic Fittings
The 10A40 wooden adapter is used in the fabrication of a passive pros-
thesis. The adapter is to be milled down to a diameter of 34mm. Roughen
the inside of the forearm socket with 634A3 acetone. Allow the acetone to
evaporate prior to gluing the wooden adapter into the forearm with 634K18
Sealing Resin Compact Adhesive.
Alignment of the hand should always be performed in the neutral-zero po-
sition. However, the individual conditions and needs of the patients must
be considered in all cases.
4.3.3 Body-Powered Prosthetic Fitting
For a body-powered prosthetic fitting, 10V18=34 or 10V36=34 Wrist Unit
is being used. After separating the wrist unit, the lamination ring is glued
into the roughened inside of the forearm using 636K18 Sealing Resin
Compact Adhesive.
After performing the prosthetic fitting (chapter 4.3.2 to 4.3.3), the cover
and the countersunk head screw (fig. 12) are mounted. Both parts are
routed through the inside of the outer socket and connected to the lower
part of the elbow component. The countersunk head screw is tightened
with a torque of 5 Nm.
5 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
18 | Ottobock
Tabla de contenido
