Sawing With The Base Adapter - Festool CARVEX PSC 420 EB Manual De Instrucciones

WARNING
Sawing cutting depths
Risk of injury
► Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 0° cuts, we recommend setting the an­
gle table to a small negative angle to guar­
antee smooth operation.

12.4 Sawing with the base adapter

The ADT-PS 400 base adapter is used for at­
taching your jigsaw to the Festool guide rail and
the KS-PS 400 core maker.
With guide rail and core maker: Observe
the max. material thickness of 6/8"
(20 mm) and only use cross-set saw blades
(FSG).
8
8-1
8-2
ADT-PS 400
Attention: Only use with
materials thinner than
20mm and cross-set sawblade!
Installing the base adapter
► Remove the saw table [1-11] (see section
9.4 ).
► Position the base adapter [9-1] against the
saw table support.
► Close the lever [1-9].
Ensure that the base adapter is firmly seated in
the guide.
Also use the extractor connector [1-8]
with the base adapter.
Adaptation to the FS 2 guide rail
The FS 2 Festool guide system (Fig. [10])
makes it much easier to produce straight and
precise cuts.
► Place the jigsaw with attached base adapter
[9-1] on the guide rail.
Adaptation to the core maker
The core maker can be used to create circular
cuts with a diameter between 4-3/4" and
English
9
9-1
10
17