Installing The Cam1000 / Bsc01; Instructions Before Installation (Change Acceptance); Connecting The Cam1000 / Bsc01 - Dometic CAM 1000 Instrucciones De Montaje Y De Uso

Installing the CAM1000 / BSC01

6 Installing the CAM1000 / BSC01
See fig. 2 to fig. 0
6.1

Instructions before installation (change acceptance)

• The system requires a change acceptance by a testing laboratory (for example, DEKRA, TÜV).
• Please observe the manufacturer's installation guidelines.
• The load status has no effect on the function of the system as long as the installation instructions
are observed.
• The electrical connection and commissioning may only be carried out by a specialist in accord-
ance with the information in this assembly and operating manual.
• The device may only be put into operation if the user is aware of the risks and dangers resulting
from the use of the device.
Supplement to fig. 2 to fig. 8
Note the following during installation:
• Note the detection range dependent on the height of the vehicle:
– Operating mode A for vehicles from 2 m to 3 m (fig. 2 to fig. 3) in height:
Visible area: 37 m x 6 m, 165° FOV (field of view)
Active area: 8 m x 4 m
– Operating mode B for vehicles from 3 m to 4 m (fig. 7 to fig. 5) in height:
Visible area: 19 m x 8 m, 140° FOV (field of view)
Active area: 8 m x 4 m
• Use the base if the box body blocks the view to the detection zone (fig. 8).
Supplement to fig. 0
• The system only fulfills the conditions if the monitor is mounted in the area of the right A-pillar
(30° to the viewing axis straight ahead).
7

Connecting the CAM1000 / BSC01

See fig. a
Observe the following:
• As far as possible, use original ducts for laying the cables, or other suitable options such as
paneling edges, ventilation grilles or dummy plugs. If no openings are available, you must drill
holes for the respective cables. Check beforehand that there is sufficient space on the other
side for the drill head to emerge.
• Wherever possible, lay cables inside the vehicle, as they are better protected there than out-
side.
• If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
8
CAM 1000 / BSC 01
EN