Festool CARVEX Serie Manual De Instrucciones página 19

cessories and consumable material from other
suppliers will most likely affect the quality of
your working results and limit any warranty
claims. Machine wear or your own personal
workload may increase depending on the ap-
plication. Protect yourself and your machine,
and preserve your warranty claims by always
using original Festool accessories and Festool
consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli-
cations that are specially designed for your
Festool jigsaw.
10.2 Sawing with special base runners
The special base runners protect high-quality
surfaces against scratches and scores.
X
Press in the base runner at position [6-1].
X
At the same time, push the base runner
forwards.
X
Mount another base runner and push it to
the rear until it engages.
10.3 Sawing with the angle table
The angle table WT-PS 400 is used for sawing
interior and exterior angles up to 45° and
pipes.
Dust extraction is not possible when
sawing with the angle table!
Installing the angle table
X Remove the saw table [1-11], (see chapter
7.4).
X Position the angle table against the saw ta-
ble support.
X
Close the change lever [1-9].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
X Turn the adjusting wheel
desired angle.
You can set the values -45°, 0° and +45° us-
ing the scale [7-2].
Angle table
position
Picture [7A] Angle, interior angle
Picture [7B] Angle
Picture [7C] Exterior angle, pipes
[7-1] to set the
Application
WARNING
Sawing cutting depths
Risk of injury
X
Select the saw blade length and cutting
depth so that the saw blade always stays
in the workpiece.
L For 90° cuts, we recommend setting the
angle table to a small negative degree val-
ue to guarantee stable running.
10.4 Sawing with the adaptation table
The adaptation table ADT-PS 400 is used for
attaching your jigsaw to the Festool guide rail,
the circle cutter KS-PS 400 and the CMS mod-
ular system.
Installing the adaptation table
X
Remove the saw table [1-11], (see chapter
7.4).
X Mount the adaptation table
saw table support.
X Close the change lever [1-9].
Ensure that the adaptation table is firmly seat-
ed in the guide.
L Use the extractor connector
the adaptation table.
Adaptation to the guide rail FS 2
Using the Festool guide system FS 2 (Fig.
[9]) makes it easier to produce straight and
precise cuts, in particular, with material thick-
nesses up to 20 mm.
X
Place the jigsaw with attached adaptation
table [8-1] on the guide rail.
Adaptation to the circle cutter
The circle cutter can be used to create circular
cuts with a diameter between 120 and 3000
mm. The circle cutter can be installed from
both sides on the adaptation table.
X
Place the jigsaw with attached adaptation
table on the adapter
cutter.
X
Insert the centring mandrel
hole [10-4] on the circle cutter aligned with
the saw blade.
X
Clamp the measuring tape to the circle cut-
ter using the rotary knob [10-5].
Recommended when using the circle cutter:
X
Cut in an anticlockwise direction.
X Work at a slow rate of advance.
CARVEX
GB
[8-1] on the
[1-8] also with
[10-1] on the circle
[10-2] in the
19