I Feel - Mitsubishi Electric MCF-GA35VB Manual De Instrucciones

"I FEEL..." AUTO OPERATION
With the " (I FEEL...)" auto operation mode, the optimum room condition can be set automatically
with a one-touch operation.
To start operation:
I
Press the
CLOCK
AMPM
When the "
controlled at the optimum temperature.
TOO TOO
ON/OFF
WARM COOL
To stop operation:
I
Press the
FAN STOP
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
I FEEL COOL
If you feel slightly warm,
VANE START
FAN DRY
I
MODE HR.
ECONO COOL MIN.
RESET CLOCK
If you feel slightly cool,
I
MODE
When " (I FEEL...)" is not selected, press the
until it is set.
Each time the button is pressed, the operation mode is changed
(I FEEL...) → (COOL) →
in sequence :
(DRY) →
(FAN)
Description of "AUTO RESTART FUNCTION"
• These units are equipped with an auto restart function. When the main power is turned on, the air conditioner will start
operation automatically in the same mode as the one set with the remote controller just before the shutoff of the main
power.
• If the unit was set to off with the remote controller before the shutoff of the main power, it will remain stopped even after
the main power is turned on.
• If the unit was in the emergency operation before the shutoff of the main power, it will start operation, at main power
on, in the same mode as the one set with the remote controller before the emergency operation.
• If the unit is operated in "I FEEL..." mode before power failure, the operation is not memorized. In "I FEEL..." mode, the
operation is decided by the initial room temperature at (re)start.
6
ON/OFF
button.
(I FEEL...)" mode is selected, the air conditioner is automatically
ON/OFF
button.
TOO
WARM
Press the button to lower the temperature.
One press lowers the temperature by about 1°C.
TOO
COOL
Press the button to raise the temperature.
One press raises the temperature by about 1°C.
FAN
button
I FEEL COOL
VANE
FAN DRY
MODE
ECONO COOL
Description of "I FEEL..." mode
Details of operation
According to the room temperature when the operation starts, the operation mode is automatically set to either COOL or
DRY. However, when operation is started again within 2 hours after it is stopped, the same operation mode before the
operation is stopped is selected. The operation mode selected first is not changed even if the room temperature changes.
If the operation mode does not match the room condition, select the appropriate operation mode by pressing the
button.
Details of auto operation
Room temperature
when started
About 25°C or higher
About 25°C or lower
Note:
When both Operation Indicator lamps are lighting, as the air conditioner is operating to reach the target tem-
perature, the set temperature may not be changed. In this case, please wait until the lighting of Operation Indica-
tor lamp changes from two to only one and then change the set temperature.
Details of display on the indoor unit
The operation indicator at the right side of the indoor unit indicates the operation state.
STOP
START Operation indicator lamp
HR.
Indication
MIN
This shows that the air conditioner is operating to reach the
target temperature. Please wait until the target temperature
is obtained.
This shows that the room temperature is approaching the
target temperature.
Operation mode Target temperature
(initial state)
COOL About 24°C
DRY —
Operation Indicator
Lighting
Not lighting
Operation state
MODE
Difference between target
temperature and room temperature
About 2°C or more
About 2°C or less