Indoor Unit; Remote Controller; Outdoor Unit; Preparation Before Operation - Mitsubishi Electric MLZ-KA-VA Serie Manual De Instrucciones

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART

Indoor unit

Air inlet
Air outlet
Air cleaning fi lter
(Anti-Allergy Enzyme
Filter, option)
Display section
Remote control
receiving section
Emergency
operation switch
Page 4

Outdoor unit

Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
1.
Remove the front lid.
3.
Install the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
En-3
Horizontal vane
Vertical vane
Intake grille
Air fi lter
(Catechin air
fi lter, option)
Operation indicator
lamp
Safety strings
Air inlet (back and side)
Piping
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA
alkaline batteries fi rst.

Remote controller

Operation display
section
ON/OFF
(operate/stop)
button
FAN speed
control button
Page 5
Operation
select button
Page 4
ECONO
COOL
button
Page 5
VANE
control button
Page 5
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Setting current time
1.
Press RESET.
2.
Press CLOCK.
4.
Press CLOCK again.
• Press RESET and CLOCK gently using a thin
stick.
If the RESET button is not pressed, the remote
controller may not operate correctly.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
90°
Operate the remote control-
ler in the area where signal is
received, and beep is heard.
Temperature buttons
Page 4
Off-timer button
Page 5
On-timer button
Page 5
WIDE VANE
control button
Page 5
TIME set buttons
Pages 3, 5
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
3.
Press the TIME buttons to set
the time.
Each press increases/de-
creases the time by 1 minute
(10 minutes when pressed
longer).