Ordering Replacement Parts; Disposal And Recycling - Gardol GLH-E 2845 B Manual De Instrucciones

•
Never clean the shredder by spraying with
water.
•
Prevent water getting inside the machine at
all cost.
•
Check the chassis securing screws from time
to time to ensure that they are tight.
•
If you do not intend to use the shredder for a
lengthy period, protect it from corrosion using
environmentally friendly oil.
•
Store the device in a dry room.
•
Store the device out of reach of children.
The equipment must be cleaned and conser-
ved at the end of the season.
Important: Wear work gloves!
Undo the 4 Allen screws (Fig. 15a/Item K) fully.
The Allen screws can only be undone – they can-
not be removed. Undo the retaining screw on the
bottom side of the equipment (Fig. 15b/Item L) as
far as the stop. The retaining screw can only be
undone – it cannot be removed. Now you can take
off the cover (Fig. 15a/Item M). Clean the cutting
compartment, the counter blade and the cutting
unit and cover them with a thin coat of vegetable
oil before installing everything again. At the begin-
ning of the new season the counter blade must be
correctly adjusted as described under 6.8.

8.2 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offices.
Anl_GLH_E_2845_B_SPK7.indb 20
GB
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 20 -
13.05.15 14:19