User Menu; Start Up - Cadel CLOE Manual De Instalación

10.4

USER MENU

By once pressing P3 key you can hace access to user parameter controlling. To let them slide press P5 and
P6 keys. They are:
POS. REFERENCE
FAN ADJUST
1
(supplementary)
2 SET CLOCK
3 SET CHRONO
SELECT
4
LANGUAGE
5 STAND-BY MODE
BUZZER MODE
6
(audio alarm)
7 INITIAL LOAD
8 STOVE STATE
TECHNICA
9
SETTING
10 SET FLAME
10.5

START UP

We remind you that the first ignition must be carried out by a specialized and authorixed technician who
will check that all is installed in compliance with current regulations and checks the efficiency.
• If inside the combustion chamber there are booklets, manuals, etc..., remove them.
• Check if the door is correctly closed.
• Check if the stove is correctly inserted in the electric socket.
• Before switching the stove on, assure you the burning pot is clean.
• To start the stove up, keep pressed P4 key for an instant till it will be shown "START" and "PREHEATI WAIT":
the preheating of the ingnition resistance starts. After 2 minutes about, it will be shown "PELLET LOAD,
FLAME WAIT", in this phase the auger loads the pellet and the heating of the resistance continues. When
the temperature is sufficiently high (after 7-10 minutes about), the ignition is considered as happened
and on the display shows "FIRE PRESENT".
• Completed the phase "FIRE PRESENT", the control unit enter the "WORK" phase showing the set calorific
power and ambient temperature. It is in this phase that P5 and P6 keys settle the stove power from 1 to
5. If the value of the ambient temperature exceeds the limit set on the keyboard on the temperature
setting, the calorific power will be carried at the minimum showing "WORK, MODULATI". When the
ambient temperature turns back below the set temperatur, the stove turns back to the set power.
CLOE - SQUARE
DESCRIPTION
Module not included in this type of stove.
Set date and time. The board is provided with a lithium battery which enables a clock
autonomy of 3/5 years. See CLOCK SETTING page 79.
Press once P3: "CHRONO ENABLE" appears. Press P3 again and with P1 and P2
put in "OFF" or "ON". For daily, week-end or weekly programming, see DAILY
PROGRAMMING page 79. CAUTION: do not active if STAND-BY function is active!
Press once P3 key and with P1 and P2 keys select the desired language.
It activates a function which, if the set ambient temperature has been exceeded for
more then 10 minutes, start the switching off phase up. If the ambient temperature
has fall at more than 2°C, the stove will restart automatically up, starting from START
UP page 77. Press once P3 key and with P1 and P2 keys put in "OFF" or "ON".
CAUTION: do not activate if CHRONO function is active!
Press once P3 key and with P1 and P2 keys put in "OFF" or "ON".
When the stove has its first ignition, the auger is completely empty. If it should be
necessary do a precharge by pressing P3 key, then P1 key for starting up and P4 key
for stop.
It shows all parameters connected to the stove state: this is a menu for the Authorized
Techinician
Only for the Authorized Technician.
It enables to set the flame dipending on the draught of the chimney flue.
EN
77