Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To control a DVD player"
Program the remote
control to recognize the
brand of your DVD
player (see
"Programming the
remote control to
operate your other
devices" below). The
buttons shown at right
will then control the
DVD player.
Press "DVD" first.
h"
Mute
Number
Volume +/-
Pic Size
DVD MENU
AT
_1_
DVD
DVD Ski
TOP
Programming
the remote
control to operate
your other devices
5.
For
Cable
This remote control is pre-programmed
to operate most Toshiba
satellite receivers, VCRs, and DVD players. To control a non-Toshiba
device (or a Toshiba device that the remote control is not pre-
programmed to operate), you must follow the steps below to program
your remote control.
1.
Refer to the device code tables (on pages 17 and 18) to find the
corresponding code for your device.
If more than one code is listed, try each one separately until you
find the one that works.
2.
If you are programming the remote control to operate your:
* Cable TV converter/satellite
receiver: Press "CBL/SAT."
* VCR: Press "VCR."
* DVD player: Press "DVD."
3.
While holding down RECALL, press the Channel Number buttons
to enter the three-digit code for your device within 10 seconds.
Note:If you do not enter the code within 10 seconds from step 3,
or if you enter the wrong code, this operation is canceled.
4.
Point the remote control at the device and press POWER to test
the code.
* If the device responds, you entered the correct code.
* If the device does not respond, repeat steps 1-4 using another
code.
Press "TV" to control the TV.
future reference, write down the codes you used:
TV converter/satellite
receiver code
VCR code
DVD player code
Power
Recall
Channel
Numbers
TV
VCR
DVD
CBL/SAT
NOte:
• When shipped from the factory, the remote
control is set to operate your TV.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
16
3W70721A
En p15-22
16
20/3/06, 9:33 AM
Capítulos
Tabla de contenido
