Festo 8082795 Instrucciones De Servicio página 47

•
Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the cable and the fuse.
– If these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.
•
Use only connecting cables with safety plugs for the electrical connections.
•
When laying connecting cables, make sure they are not kinked or pinched.
•
Do not lay cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
When replacing fuses, use specified fuses only with the correct current ratings and tripping
characteristics.
•
The device is not equipped with an integrated fuse unless specified otherwise in the technical data.
•
Always pull safety plugs only when disconnecting connecting cables – never tug the cables.
•
Hazard-free operation of the device is no longer possible in the case of:
– Visible damage
– Malfunction
– Incorrect storage
– Incorrect transport.
– Switch off the power supply immediately.
– Protect the device against inadvertent restart.
Attention
The surfaces of motors as well as any attachments in the vicinity of the motors may
become hot. Avoid contact. A warning notice is attached at the corresponding
points.
Caution
There is a risk of crushing at various points on the station. Never reach into the
station while in operation.
© Festo Didactic 8083287
Storing/Conveyor station
47