Event Log; Replacement Parts - Hach LANGE Manual Del Usuario

Table 7 Error messages (continued)
Bit Message
14 Reagent warning
15 Maintenance required
warning
Table 8 Status indicator messages
Bit Message
0 Calibration in progress
1 Cleaning in progress
2 Service/Maintenance menu
3 Common error
4 Measurement 0 Quality Bad Precision of measurement is out of specified
5 Measurement 0 Low Limit
6 Measurement 0 High Limit
7 Measurement 1 Quality Bad Precision of measurement is out of the
8 Measurement 1 Low Limit
9 Measurement 1 High Limit
10 Measurement 2 Quality Bad Precision of measurement is out of the
11 Measurement 2 Low Limit
12 Measurement 2 High Limit
13 Measurement 3 Quality Bad Precision of measurement is out of the
14 English
Indication
The reagent system requires attention
The device requires maintenance
Indication
The device is in a calibration mode.
Measurements may not be valid.
The device is in a cleaning mode.
Measurements may not be valid.
The device is in a service or maintenance
mode. Measurements may not be valid.
The device has recognized an error. See
Error Register for Error Class.
limits.
Measurement is below the specified range.
Measurement is above the specified range.
specified limits.
Measurement is below the specified range.
Measurement is above the specified range.
specified limits.
Measurement is below the specified range.
Measurement is above the specified range.
specified limits.
Table 8 Status indicator messages (continued)
Bit Message
14 Measurement 3 Low Limit
15 Measurement 3 High Limit

Event Log

Refer to Table 9 for diagnostic device information.
Table 9 Event log
Event Description
ADDRESS Adjusted Profibus address
DATA ORDER Indicates the data order of 2 word variables in the cyclic
and acyclic Profibus telegram
SIMULATION Indicates if the simulated data is set into the cyclic
Profibus telegram.
SENSOR POWER Timestamp of the Profibus card power up
SET DATE/TIME Setup timestamp of the internal timer of the Profibus card
NEW CONFIG Timestamp of a new configuration
AUTO CONFIGURE Timestamp of a new menu setting
CODE VERSION Timestamp of a new software download (Software
version)

Replacement parts

W A R N I N G
Personal injury hazard. Use of non-approved parts may cause
personal injury, damage to the instrument or equipment malfunction.
The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
Indication
Measurement is below the specified range.
Measurement is above the specified range.