Using The Cleaner; Control Panel; Important; Use - IPC Skid Fuego LS 2675 E Manual De Instrucciones

LIFTING WITH HOOKS
To lift the cleaner with a hook,
sling it as shown in fig. 7
WEIGHT 220 kg.
LIFTING WITH A FORKLIFT
TRUCK
To lift the cleaner with a forklift
truck insert the forks in the
slots provided. (fig. 8).
USING
THE CLEANER

CONTROL PANEL

A - Detergent control tap
B - Temperature regulator
C - Start Switch.
STARTING THE CLEANER
Turn on the water supply tap
(fig. 5A).
STARTING THE PETROL
ENGINE:
To start the petrol engine
proceded as follows:
1) Place the petrol tap lever
in the open ON position (fig.
10A).
2) Set the choke lever B
in start position (fig. 10B). If
the engine is warm or there
is a hight environment at
temperature, this operation is
not necessary.
English
3) Start petrol engine by means of the proper switch (fig. 9C).
It is also possible to start the engine by means of the self-winding
cord.
4) Once the engine has been started, return the choke lever
B (fig. 10) back to the original position.
STOPPING THE PETROL ENGINE
To stop the engine proceed as follows:
1) Turn start switch to "0" position.
2) Set the fuel tap lever A in OFF position (fig. 10A).
FIG. 7
!
Warning
The high pressure water jet
generates a reaction force in
the lance. Keep a firm grip on
the lance handle.
Press the trigger on the gun
and begin washing.
!
Danger
Do not block the handle lever
in the delivery position.

IMPORTANT!

FIG. 8
To eliminate any impurities
or air bubbles from the
water circuit we advise
starting the cleaner for the
first time without the lance and letting the water run out
for a few seconds.
Impurities could block the nozzle and cause malfunction
(Fig. 11).
N.B. When releasing the trigger, the engine automatically redu-
ces the number of rpm. It returns to a normal speed when the
trigger is pressed again.
To use the cleaner with hot water, turn the temperature regulator
to the recommended washing values.
STOPPING THE CLEANER
FIG. 9
1) Switch off the burner by turning the temperature regulator
to pos. "0" (fig. 9B).
2) Let the cleaner run with cold water only for at least 30 seconds
to cool down the boiler.
3) After using with detergent, flush out the intake circuit; place
the detergent suction hose in a tank of clean water and let the
pump run for 1 minute with the dosing tap turned fully on and
the lance in detergent delivery condition.
4) Stop the petrol engine as described in the paragraph "STOP-
PING THE PETROL ENGINE".
5) Discharge the pressure from the H.P. hose by pressing the
trigger on the gun.
FIG. 10
- 21 -
FIG. 11