Intended Use; Preliminary Operations - IPC Skid Fuego LS 2675 E Manual De Instrucciones

INTENDED USE

This appliance is intended exclusively for cleaning machines,
vehicles, buildings and general surfaces suitable for treatment
with a high pressure jet of detergent solution between 25 and
250 bar (360 - 3600 PSI).
!
Warning
This appliance has been designed for use with the detergents
supplied or recommended by the manufacturer. The use of
other detergents or chemicals may influence the safety of the
appliance.
This appliance has been designed for non-professional use.
Over long use may adversely affect functioning of the cleaner.
This appliance must be used only for the purpose for which it
was specifically designed.
All other uses are to be considered incorrect and therefore
unreasonable.
Examples of unreasonable
- Washing surfaces not suitable for cleaning with a high pre-
sure jet.
- Washing people, animals, electric equipment or the machine
itself.
- Using unsuitable detergents or chemicals.
- Blocking the trigger (lever) of the lance in delivery position.
- Using accessories not recommended by the manufacturer.
- Using the cleaner in enclosed spaces without exhaust pipes
to evacuate harmful gases to the outside.
The manufacturer cannot be held responsible for any damage
due to improper, incorrect or unreasonable use. As far as safety
rules are concerned, the cleaners are manufactured according
to the European Standard.

PRELIMINARY OPERATIONS

UNPACKING
After unpacking, ensure that the cleaner is undamaged.
If in doubt, do not use the machine.
Contact your dealer.
Packaging (bags, boxes, nails, etc) is potentially dangerous and
should be kept out of reach of children. It should be disposed of
or retained in respect of national environmental legislation.
FITTING THE SEPARATE PARTS OF THE MACHINE
All the fundamental parts and safety devices of the machine are
assembled by the manufacturer.
For reasons of packing and transport, some secondary cleaner
parts are supplied separately.
The user must fit these parts as explained in the instructions
supplied in each assembly kit.
use:
English
DATA PLATE:
The data plate bearing the
main technical characteristics
of your cleaner is located on
the trolley and is always visible
(fig. 1).
!
Warning
When buying your cleaner, ensure that it has an identifica-
tion plate. If there is no plate, inform the manufacturer and/
or the dealer immediately. Machines without a plate must
not be used and the manufacturer declines all responsibi-
lity for them. Products without a plate must be considered
anonymous and potentially dangerous.
FILLING THE DETERGENT
TANK
!
Warning
From the range of recommen-
ded products, choose the one
most suited to the washing job
to be done (fig. 2) and dilute
it with water according to the
instructions on the pack.
Fill the detergent tank with
the diluted product.
Ask your dealer for the catalogue of the detergents that can be
used depending on the type of washing job to be done and the
type of surface to be treated.
After using a detergent, the detergent intake circuit must be
flushed out with clean water.
FILLING THE FUEL TANK
Fill the tank with fuel for Diesel
motors (fig. 3).
!
Warning
Do not use different fuel
from that indicated on the
identification plate.
Check the fuel level from
time to time while the clea-
ner is operating.
Attempting to use the clea-
ner without fuel may cause
damage to the fuel pump.
- 19 -
FIG. 1
FIG. 2
FIG. 3