Operation - Dometic 310 Manual De Instrucciones

Installation / Operation / Cleaning
3 . Verify that floor flange seal is installed on base of toilet (fig .
over floor flange . Align holes in toilet base with T-bolts as toilet is lowered onto floor flange .
Toilet must be aligned so that outlet of base fits inside of floor flange outlet hole .
Note
Entire toilet base does not rest completely on floor yet . Floor seal must be compressed in
following steps .
4 . Install floor mounting nuts and washers onto T-bolts . Carefully torque nuts to 30-40 inch-
pounds . DO NOT OVERTIGHTEN . Alternate between sides when tightening to prevent
distortion of base . When tight, base should be securely attached and flat against floor .
Attach bolt covers onto nuts . (Fig .
5 . If toilet is being installed in a shower stall, apply a bead of caulk around base of toilet to prevent
water seepage under base .
6 . Connect water supply line and torque connection to 30-40 inch-pounds .
DO NOT OVERTIGHTEN . (Fig .
7 . Turn on water supply line . Flush toilet several times and check for leaks .
7

Operation

7.1 Add water to bowl
To add water to the toilet, press the flush pedal
part way down . Water flows into the bowl while
flush ball remains closed . If the flush ball moves,
let up on the pedal slightly . Adding water to an
empty bowl helps prevent holding tank odors from
entering the living space . Adding water is recom-
mended prior to flushing solids and toilet paper .
7.2 Flush toilet
To flush, press pedal down until it contacts the
floor . Release pedal after complete flush .
• When flushing liquids, press the pedal for 1-2 seconds .
• When flushing solids, press pedal until contents are rinsed from bowl . Flushing longer than
necessary will cause holding tank to fill too quickly .
A small amount of water will collect in the bowl after a flush to create an airtight seal .
Note
Residual water trickle in ceramic bowls: Due to integrated rim of models 310, 311, 320
and 321 toilets, water may continue to trickle into toilet bowl for up to 20 minutes after
flushing . If water trickle continues after 30 minutes, replace water valve .
Note
To ensure holding tank odors do not enter the living space, make sure 1 inch (24 mm) of
water remains in the toilet bowl . Because of variations in plumbing systems and user
operation, the "add water" function may be required to achieve the 1-inch water depth .
5 B, page 2)
5 C, page 2)
Dometic Model 310 Toilet
5 A, page 2) . Carefully set toilet
Flush directions are located under
toilet seat lid.
7