Connecting The Cooler - Dometic Waeco MyFridge MF-40 Instrucciones De Uso

_mf-40.book Seite 22 Montag, 3. Dezember 2007 11:08 11

Connecting the cooler

6 Connecting the cooler
➤ Place the cooler on a firm base.
Ensure that the ventilation slots are at least 10 cm away from the wall so
that the heat that arises during operation can be drawn off.
e
Caution – risk of damage
Only operate the cooler on a single power source. Never connect it
to a 12 V on-board supply and a 220–240 V AC mains supply
simultaneously.
6.1 Connecting to 220 V – 240 V
e
Caution
Check that the voltage specification on the type plate is the same
as that of the power supply.
➤ Plug the earthed plug into a properly installed safety plug socket.
➤ Isolate the bare end of the unused 12 V cable (fig. 1 2, page 3).
6.2 Connecting to 12 V
e
Caution
Only select 12 V DC operation (battery mode) if you are using a
battery monitor or if the alternator in your vehicle provides sufficient
voltage.
I
Note
Disconnect the cooler from the battery when the engine is not
running as otherwise it will run down.
Note the following, to ensure that the cooler has a suitable power supply:
The battery must be in good condition.
The electrical wires in the vehicle must have a cross section of at least
1.5 mm².
All wires must be securely fastened along their entire length.
22
MyFridge MF-40