General Operations; Adjusting The Sound Characteristics - Blaupunkt Sacramento CD33 Instrucciones De Manejo E Instalación

General Operations

Turning the power On/Off
Press the PWR to turn the unit On or Off.
Tip
When you turn on the unit, "HELLO" will be displayed then
"WELCOME" will momentarily be displayed before actual
power on.
When you turn off the unit, "SEE YOU" will be displayed then
"GOOD-BYE" will momentarily be displayed before actual
power off.
You can edit these messages. (See "Turn on/off message edit").
Volume Control
Rotate the VOL dial to adjust the volume.
+ +
Volume up
VOL VOL
Volume down
- -
Muting the sound
Press MUTE / SENS .
To restore the previous volume level, press MUTE / SENS
Mute level can be adjustable. (See " Adjusting the Sound
Characteristics ")
Switching the Source (Selecting auxiliary
input)
You can connect auxiliary equipment (Portable cassette player,
etc) to this radio via optional AUX-IN cable. (See page 13)
CD
Each time the is pressed, the operation source will
change over as shown below;
RADIO CD CD changer or AUX
Press the BAND to return to tuner mode.
SacramentoCD33_Eng 3
Notes
• If the CD button is pressed when no CD has been loaded
into the unit, The CD mode will skip to the CD changer
mode or AUX mode.
Also, if the CD changer is not connected, the system will
move across to the AUX mode regardless of whether auxil-
iary equipment is connected or not (" AUX " will be dis-
played.)
• It is not possible to switch to the AUX mode when the CD
changer is connected.
Setting the Clock
The clock uses a 12-hour display system.
1.
Turn the ignition key to the ON position.
2.
Press the PWR to turn on the unit.
3.
Repeatedly press the DISP to display "CLK ADJ.
4.
Use the following buttons and dial to set the clock. (The blink-
ing section can be adjusted.)
: To switch Hour/Minute blink
SC/PS
again.
+ +
VOL VOL
: Adjust the Hour and minute
- -
5.
Press the DISP momentarily to complete the Clock set-
ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the DISP while the ignition switch is in the " OFF " po-
sition.

Adjusting the Sound Characteristics

1.
Each time you press the to select the desired ad-
AUDIO
justment mode as table below.
After pressing the AUDIO , you can also select with TUN/
TRK dial or .
DISP
2.
Rotate the VOL dial to adjust the selected item.
Use the following tables as a guide for adjusting the set-
tings in each mode.
Adjust within 5 seconds after selecting the item. After 5
seconds, the unit returns to previous indication.
+ +
VOL VOL
- -
Adjustment Range
bAS B 0 (BASS)
B –5 ~ B 0
T 0 (TREBLE)
TRE
T –5 ~ T 0
Ld LOUD
LOUD OFF –
bAS X-BASS
X-BASS 0 ~
B 0 (BALANCE)
bAL
B L9 ~ B 0
FAd F 0 (FADER)
F R9 ~ F 0
AU GAIN
–6 ~ 0
LEVEL
LMt
0 ~ 50
MUt LEVEL
0 ~ 20
•A italicized letter is an initial value.
2/5/03, 4:27 PM
~ B +5
~ T +5
LOUD ON
X-BASS 4
~ B R9
~ F F9
~ 3
~ 80
~ 80
E-3