Changing The Base Runner; Aluminium Processing; Accessories - Festool OF 2200 EB Manual De Instrucciones Original/Lista De Piezas De Repuesto

Remove the base runner [14.1].
Release the lever [14.4] again.
Insert a copying ring [14.3] in the correct posi-
tion on the router base.
Insert the tabs [14.2] on a base runner into the
router base.
Push down the base runner until it engages in
the router base.
The overhang Y of the workpiece in relation the
template [Fig. 15] is calculated as follows:
Y = ½ (diameter of copying ring minus diameter of
routing bit)
c) Edge trimming
Routing tools with a bearing guide are required
when the machine is used for edge trimming. The
machine is then guided in such a way that the
bearing guide rolls off the workpiece.
When trimming edges, always use the chip defl ec-
tor KSF-OF to improve dust extraction.
d) Routing with a guide system FS
The guide system (partly as an accessory) makes
it easier to route straight grooves.
Secure the guide rail to the workpiece using
clamps [16.4].
Insert the base runner [16.3] for the guide stop
into the router base (see "Changing the base
runner").
This base runner is offset to compensate for
the height of the guide rail.
Secure both guide rods [16.6] with the rotary
knobs [16.5] and [16.9] on the guide stop.
Unscrew the rotary knob [16.1].
Insert the guide rods [16.6] into the grooves on
the router base.
Place the router with the guide stop on the
guide rail.
If required, you can adjust the play of the guide
stop on the guide rail by adjusting the two guid-
ance jaws [16.2] with a screwdriver.
Slide the router along the guide rods until the
routing tool reaches the required distance X
from the guide rail.
Screw up the rotary knob [16.1].
Unscrew the rotary knob [16.10].
Turn the adjusting wheel [16.7] to adjust dis-
tance X more precisely.
Hold the adjusting wheel [16.7] to turn the
scale [16.8] independently to "zero".
Screw up the rotary knob [16.10].

8.2 Changing the base runner

Festool offers special base runners (as an acces-
sory) for different applications.
Change the base runner as follows:
Lay the machine on its side on a stable base.
Open the lever [14.4].
Remove the base runner [14.1].
Release the lever [14.4] again.
Insert the tabs [14.2] on a base runner into the
router base.
Push down the base runner until it engages in
the router base.
Before using the base runner: remove the protec-
tive foil!

8.3 Aluminium processing

WARNING
Risk of accident - always perform the following
safety measures when routing aluminium:
Add a residual-current circuit-breaker (FI,
PRCD).
Connect the machine to a suitable dust ex-
tractor.
Remove dust deposits from the motor hous-
ing on a regular basis.
Wear protective goggles.
9

Accessories

Use only original Festool accessories and Festool
consumable material designed for this machine
because these components are designed specifi -
cally for the machine. Using accessories and con-
sumable material from other suppliers will most
likely affect the quality of your working results
and limit any warranty claims. Machine wear or
your own personal workload may increase de-
pending on the application. Protect yourself and
your machine, and preserve your warranty claims
by always using original Festool accessories and
Festool consumable material!
Festool offers you a comprehensive range of ac-
cessories for your router:
-
Routing tools for different applications.
-
Guide rails for straight routing.
-
Runner bases for different applications.
19