Switching The Machine On And Off; Tool Settings; Electronic Control; Changing The Router Table - Festool MFK 700 EQ Manual De Instrucciones

Switching the machine on and off

Keep the machine steady during
switching and during use by holding the handles
[3-1] [3-2] with both hands.
The switch [3-4] is an on/off switch (I = ON, 0 =
OFF).
3- 4

Tool settings

Disconnect the plug from the power
source before making any adjustments, changing
accessories, or storing power tools.

Electronic control

The machine features full-wave electronics with
the following properties:
Smooth start-up
The electronically controlled smooth start-up func-
tion ensures that the machine starts up smoothly.
Speed control
You can regulate the rotational speed steplessly
between 10000 and 26000 rpm using the adjusting
wheel [3-3]. This enables you to optimise the cutting
speed to suit the respective material.
Constant speed
The preselected motor speed remains constant
through electronic control. This ensures a uniform
cutting speed even when under strain.
Temperature control
To prevent overheating, the safety electronics
switches the machine off when it reaches a criti-
cal motor temperature. Let the machine cool down
for approx. 3-5 minutes before using it again. The
machine requires less time to cool down if it is run-
ning, i.e. in neutral position.

Changing the router table

The "large surface router table" is already fi tted as
standard. The large contact surface and precision
adjustment features of this router table enable a
high degree of accuracy. Other router tables are
included in the accessories programme.
a) Large surface router table
3- 1
3- 2
3- 3
– Slide the router table onto the retaining pin [4-1]
on the machine.
– Tighten the screw [4-2] to clamp the router table
in position.
4- 3
4
– Place the extraction hood [4-4] in position.
– Tighten the screw [4-3] to clamp the extraction
hood in position.
– Place the extractor connector [4-5] on the ex-
traction hood.
Removal is performed in reverse sequence to in-
stallation.
b) Router table for edge veneer
The "router table for edge veneer" (only in SET
scope of delivery) is designed for fl ush trimming
veneer overhang and profi le routing.
9
1
2
4- 5
4- 4
5
3
4- 1
4- 2