Adjusting The Seat Depth - Vermeiren INOVYS Manual De Instrucciones

GB
L
Assembly work is to be conducted only by authorised individuals.
L
Before using the wheelchair, all screws are to be checked for tightness.
L
The manufacturer is not liable for damages due to assembly measures in the combination of
frame, gas pressure spring and wheels, which endanger the safety of the user or full
functionality of the wheelchair.

ADJUSTING THE SEAT DEPTH

L
Note that when rebuilding the seat depth in the back frame area, the displacement of the
spring for adjusting the back is changed and that a gap can occur between the back and seat
cushions.
L
The manufacturer assumes no liability for any damages or injuries resulting from improper
rebuilding of the seat depth.
A
B
A
DRIVING WHEELS
Four possible wheel sockets are provided in a swage
block of the frame for the use of driving wheels
(22"/24") (A). Depending on which suspensions are
used to attach the driving wheels, the wheel position
and the seat height can be changed. The wheel
sockets attached in the delivery condition can be
attached in all sockets (boreholing)
The wheel sockets in the frame tubing (B) serve only
to attach 16" wheels (transit version).
STEERING WHEELS
In the standard model, the INOVYS is delivered with
two 8" steering wheels (200 mm x 50 mm or 200 mm
x 35 mm).
Loosen the screw beneath the front seat
frame (A). Pull the front of the seat frame into
the desired position and then tighten the
screw firmly again.
L
Rebuilding the seat depth is to be
done by authorised individuals who
can judge the technical and functional
safety.
L
Make sure that all screws are secure
and properly tightened.
12
INOVYS
12/2008