Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ELECTRONIC
CONTROL
SETUP
iNSTRUCTiONS
WARM START (after power
failure)
- A few seconds
after power
is restored,
if a cycle was in progress
at the time of the power
failure, "RESELECT
CYCLE"
will flash in the display, indicating
the need for a key press to restart washer
or dryer.
WASHER
DOOR
LOCK - Prior to beginning
a cycle, there is a
door lock routine of Iock/unlock/relock,
then cycle begins.
The
door will remain locked until the end of a cycle or approximately
2 minutes
after a power
interruption.
PRICING
- After the door is opened
and then closed
following
the completion
of a cycle, the display
indicates
the cycle price
(unless
set for free operation,
where the display will flash "SELECT
CYCLE").
As coins are dropped
or debit inputs arrive, the display
will change to lead the user through the initiation of a cycle.
There are four (4) types of dryer pdcing:
Fixed
"Vend"
Pricing
A dryer setup for "Fixed Cycle"
operation
can only accept
additional
time accumulated
by increments
equal to the length of a
complete
dry cycle. A maximum
of 99 minutes
may be purchased;
no additional
credit
is given for coins dropped
with 99 minutes
in
the display.
Accumulator
Pricing
If the price is set to one coin 1, then accumulator
pricing
is
in effect. Cycle time can be purchased
one coin at a time
(PD models) up to the maximum time of 99 minutes.
Fixed Cycle With Top Off Pdcing
A dryer set to offer "Top Off" capability
will allow time to be added
to an existing dry cycle in increments
equal to the number
of
minutes
of dry time per coin (coin 1), up to 99 minutes,
regardless
of the cost required
to start the dryer. No credit
is given for coins
or debit inputs entered when the control
is displaying
99 minutes.
PN Models:
In Enhanced
Debit Mode, the top off price can be set
independently
(see VALUE OF COIN
2), and the top off time is
calculated
according
to the following
equation:
top off time =
top off price
x full cycle length
full cycle price
Penny increment
offset is not applied
to top off purchases.
FREE CYCLES
- This is established
by setting
the cycle price
to zero. When this happens,
"SELECT
CYCLE"
will appear
rather than a cycle price. Any cycle started
as a free cycle
will automatically
terminate
when the door is opened.
DEBIT
CARD READY - This washer/dryer
is debit card ready.
It will accept
a variety of debit card systems,
but does NOT
come with a debit card reader. Refer to the debit card reader
manufacturer
for proper washer/dryer
setup. In models
converted
to a Generation
1 debit card system,
debit pulses
represent
the
equivalent
of one coin (coin 1).
Control Set-up
Procedures
I M PORTANT:
Read all instructions
before operating.
PD/PN
Models:
Insert service switch
key and turn
counterclockwise.
PN Models:
Once a Generation
2 debit card reader is installed
(according
to the reader manufacturer's
instructions),
the set-up
modes can only be changed
by inserting
a set-up
card (supplied
by the reader manufacturer)
into the card slot. Inserting the service
switch
key and turning
will only allow access to the service mode.
The washer/dryer
is now in the set-up mode. The lower fabric
setting
buttons
and the lower portion
of the display are used to set
up the digital
control for the washer.
The upper three fabric setting
buttons
and the upper portion
of the display are used to set up the
controls
for the dryer.
The display can contain
4 numbers
and/or
letters and a decimal
point on both the top and bottom
display portions.
These are used
to indicate the set-up
codes and related code values available
for
use in programming
the washer/dryer.
How to Use the Buttons to Program the Controls
1. The lower-left
(PERM.
PRESS)
button
is used to adjust the
values associated
with washer
set-up
codes and the upper-left
(WHITES
& COLORS)
button
is for the dryer. Pressing
the
button
will change
the value by increments.
Rapid adjustment
is possible
by holding
the button down.
2. The lower-middle
(DELICATES
AND KNITS) button
will advance
through
the set-up
codes.
Pressing
the button
will advance
both the washer
and dryer to the next available
set-up
code.
Some set-up codes are washer- or dryer-specific
and will not be
displayed
on both the washer
and dryer portions
of the display.
Holding
down the lower-middle
(DELICATES
AND KNITS)
button
will automatically
advance
through
the set-up
codes
at a rate faster than 1 per second.
3. The lower-right
(QUICK
CYCLE) button
is used to select
or
deselect
washer
options;
upper-right
(DELICATES)
is used
for dryer option selection
or deselecfion.
30
Tabla de contenido
