Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DRYER VENTING REQUIREMENTS
(in Australia and New Zealand, refer to AS/NZS
5601.1 = Gas Installations)
Vent Hoods
102 mm (4") Diameter Exhaust Hoods
Box Hood
Louvered Hood
Angled Hood
Exhaust hood must be at least 305 mm (1 2") from the ground
or
any object that may be in the path of the exhaust
(such as flowers,
rocks, bushes,
or snow).
Vent System
Length
Maximum Vent Length/Vent Connection
Maximum
length of vent system depends
upon the type of vent
used, number of elbows,
and type of exhaust hood.
3. Tighten
hose clamp with Phillips screwdriver.
No. of
90 ° Turns
0
1
2
3
4
Vent System
Chart
(Rigid Metal Vent)
Box and
Angled
Louvered Hood
Hood
39.6 m (130 ft.)
39.3 m (129 ft.)
38.1 m (125 ft.)
36.3 m (119 ft.)
35.1 m. (115 ft)
33.2 m (109 ft.)
32.3 m (106 ft.)
30.5 m (100 ft.)
29.9 m (98 ft.)
28.0 m (92 ft.)
\
For vent systems
not covered
by the vent specification
chart, see
your parts distributor.
Provision
must be made for enough
air for combustion
and
ventilation.
(Check
governing
codes and ordinances.)
See
"Recessed
Area and Closet Installation
Instructions"
in the
"Stacked
Washer/Gas
Dryer Location"
and "Stacked
Washer/
Electric
Dryer Location"
sections.
A 102 mm (4") outlet hood is preferred.
However,
a 64 mm
(21/2'') outlet exhaust hood may be used. A 64 mm (21/2'') outlet
creates greater
back pressure
than other hood types. For
permanent
installation,
a stationary
vent system
is required.
Connect Vent
1. If connecting
to existing vent, make sure the vent is clean.
2. Using a 102 mm (4") clamp, connect
vent to exhaust
outlet in
dryer.
Vent Collar
4. Make sure the vent is secured
to exhaust
hood with a 102 mm
(4") clamp.
5. Move dryer into final position.
Do not crush or kink vent. Make
sure dryer is level.
NOTE: Do not remove vent collar.
16
Tabla de contenido
