Tabla de contenido
Idiomas disponibles
Idiomas disponibles
COM PLETE iNSTALLATiON
1. Check the electrical
requirements.
Be sure that you have the
correct
electrical
supply
and the recommended
grounding
method.
See "Electrical
Requirements"
2. Check that all parts are now installed.
If there is an extra part,
go back through
the steps.
3. Check that you have all of your tools.
4. Dispose
of/recycle
all packaging
materials.
5. Check that the water faucets
are on.
6. Check for leaks around faucets
and inlet hoses.
Electric Shock Hazard
This washer/dryer
must be earthed.
Securely tighten
all electrical
connections.
Failure to do so can result in death, fire, or
electric
shock.
7, Plug into a grounded
outlet, or connect
power.
8. To test and to clean your washer,
measure
1/2 the detergent
manufacturer's
recommended
amount
of High Efficiency
(H E)
detergent
for a medium-size
load. Pour the detergent
into the
detergent
dispenser.
Select
any cycle and allow the washer
to
complete
one whole cycle.
9. Check dryer operation.
Using a full heat cycle, let the dryer run
for at least five minutes.
Dryer will stop when time is
used up.
NOTE: Dryer door must be closed
for dryer to operate.
When door
is open, dryer stops, but timer continues
to run. To restart dryer,
dose
door and push cycle button.
If the burner does not ignite and you can feel no heat inside
the dryer, shut off dryer for five minutes.
Check that all supply
valve controls
are in "ON"
position
and that the electrical
cord is
plugged
in. Repeat five-minute
test.
23
Tabla de contenido
