Installing Stacked Washer/Dryer - Maytag M LE20PD Instrucciones De Instalación

iNSTALLiNG STACKED WASHER/DRYER
Remove Transport System
NOTE: Slide washer/dryer onto cardboard or hardboard before
moving to avoid damaging floor covering.
Excessive Weight Hazard
Use two or more people to move and install washer/dryer.
Failure to do so can result in back or other injury.
I M PORTANT: Position the washer/dryer so that the rear of the
washer is within approximately 900 mm (3 ft.) of its final location.
There are four shipping bolts in the rear panel of the washer that
support the suspension system during transportation. These bolts
also retain the power cord inside the washer until the bolts are
removed.
iMPORTANT: Remove the four shipping bolts at the rear of the
washer before operation.
1. Keep the washer/dryer in the upright position while removing the
shipping bolts.
2. Using a 13 mm (1/2") wrench, loosen each of the bolts.
3. Once the bolt is loose, move it to the center of the hole
and completely pull out the bolt, including the plastic spacer
covering the bolt. Once all 4 bolts are removed, discard the
bolts and spacers.
4. Models with separate washer power cords: Push the power
cord plug into the opening on the right side of the rear panel and
pull the power cord through the opening on the left side of the
rear panel and close holes with the attached cap. Do not pull
plug end of power cord through the right side hole.
NOTE: To avoid damage to internal washer parts or the power
cord, if the cord does not pull out of the washer rear panel easily,
do not force it. Remove the washer rear panel and guide the
power cord around the obstruction and out the hole on the left
side of the rear panel.
C H
5. Close the bolt holes with the 4 transport bolt hole plugs.
IMPORTANT: If the washer/dryer is to be transported, call your
product distributor or installer. To avoid suspension and structural
damage, your washer/dryer must be properly set up for relocation
by a trained professional.
18