JENN-AIR 8113P755-60 Manual Del Usario página 24

Oven Fan
A convection fan (select models:) is used to circulate hot air in
the oven when the convection feature is selected.
Important: The convection fan will automatically stop when
the oven door is opened.
Oven Vent
The oven vent is incorporated into the downdraft ventilation
system on the cooking surface.
When the oven is in use, the area near the oven vent may
become hot enough to cause burns. For best baking results,
do not block the vent opening.
Oven Light
The oven light automatically comes on when
the door is opened. When the door is closed,
press the Oven Light pad to turn the oven
light on and off. A beep will sound every time
_,, Light ,_
the Oven Light pad is pressed. If the oven light is on when the
door is opened, the light will go off when the door is closed.
Oven Bottom
Protect oven bottom against spillovers, especially acidic or
sugary spills, as they may discolor the porcelain enamel. Use the correct pan size to avoid spillovers and boilovers. Do not
place utensils or aluminum foil directly on the oven
bottom.
Oven Racks
Rack Positions
RACK 5 (highest position:):
Used for two-rack
cooking and broiling.
RACK 4:
Used for two-rack
baking and broiling.
RACK 3:
Used for most baked
goods on a cookie
sheet or jelly roll pan,
Three-rack Convection Cooking
(select models)
layer cakes, fruit pies, or frozen convenience foods.
RACK 2:
Used for roasting small cuts of meat, casseroles, baking
loaves of bread, bundt cakes, custard pies, frozen pies or
two-rack baking.
RACK 1 :
Used for roasting large cuts of meat and poultry, dessert
souffles, angel food cake, or two-rack baking.
MULTIPLE RACK COOKING:
Two rack: Use rack positions 2 and 5.
Three rack (convection only, select models:): Use rack
positions 1, 3 and 5 (see illustration:).
-- 5 Fiat
--4
-- 3 Fiat
--2
-- 1 Fiat
Notes:
o When convect baking on two or three racks (select
models:), check foods at the minimum suggested time to
avoid over-browning or over-cooking.
Do not cover an entire rack with aluminum foil or place foil
on the oven bottom. Baking results will be affected and
damage may occur to the oven bottom.
Three standard flat racks were packaged for the oven.
To remove:
1. Pull forward to the "stop" position.
2. Lift up on the front of the
rack and pull out.
To replace:
1. Place rack on the rack
support in the oven.
2. Tilt the front end up
slightly; slide rack back
until it clears the lock-stop position.
3. Lower front and slide into the oven.
Baking Layer Cakes on Two Racks
rack as shown.
23