Causes Of Damage; Protecting The Environment; Operating Modes; Exhaust Air Mode - Gaggenau AW 230 790 Instrucciones De Uso Y Montaje

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Causes of Damage

NOTICE:
Risk of damage due to corrosion. Always turn
appliance on when cooking to avoid
condensation buildup. Condensation can lead to
corrosion damages.
Risk of damage due to ingress of humidity into
the electronic circuitry. Never clean operator
controls with a wet cloth.
Surface damage due to incorrect cleaning.
Clean stainless steel surfaces in the grind
direction only. Do not use any stainless steel
cleaners for operator controls.
Surface damage due to strong or abrasive
cleaning agents. Never use strong and abrasive
cleaning agents.
Risk of damage from condensation back flow.
Install exhaust vent at a slight downward slope
away from the appliance (1° slope).

Protecting the environment

Unpack the appliance and dispose of the packaging
in an environmentally friendly manner.
8

Operating modes

You can use this appliance in the air extraction or the
recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct
used for ventilating furnace installation areas.
If the ventilation is intended to pass through a
smoke or exhaust chimney that is not in
operation, the responsible area heating
inspector must give approval.
If the ventilation passes through an external wall,
use a telescope wall sleeve.

Circulating-air mode

The air that is drawn in is cleaned by the
grease filters and an activated carbon
filter and conveyed back into the kitchen.
Note: To bind odors in circulating-air mode, you must
install an activated carbon filter. The different
options for operating the appliance in circulating-air
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or
from the Online Shop. The accessory numbers can
be found at the end of the instructions for use.
When used in recirculation mode, to reduce the Risk
of Fire and Shock use only conversion kit Model
AA200110 / AA200812. Please refer to the section
"Accessories" in this manual.
Tabla de contenido
loading

Tabla de contenido