General Set Up And Spray Gun Use - 3M 07 Manual Del Usuario

General Set Up and Spray Gun Use

For additional instructions refer to your cup or fluid source manual.
Note: Flush the spray gun before using
Adjusting the Fluid Flow
Needle Adjustment Screw
The fluid flow can be adjusted by using
the needle adjustment screw as noted
in Fig. 1. As a starting point, gently turn
the knob clockwise until you have very
little needle travel (pull trigger to verify).
Do not over-tighten. After the needle
travel has stopped, further tightening
will only serve to compress the spring
and will not aid in adjustment. Next
turn the knob counter-clockwise two
full turns. These adjustment procedures
will serve only as a starting point. Fine
Fig. 1
tuning of these adjustments will be
based on your material and technique.
3
8