General Set Up And Spray Gun Use - 3M Accuspray HGP Manual De Proprietário

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57

General Set Up and Spray Gun Use

Note: Complete steps below before connecting spray
gun to air source.
One atomizing head will already be semi-attached
to the spray gun body in the package. You only
need to fully engage and secure onto the spray
gun body. Follow the procedure below.
Attaching the Atomizing Head
1. Pull trigger back and hold.
2. Slide the atomizing head over the fluid needle
and push towards the spray gun body making
sure the release buttons are aligned with the
latch openings.
3
3. Secure the atomizing head and listen for the
"clicking" sound for full engagement then
release the trigger.
Note: It is not necessary to pull the trigger back when
changing the atomizing head. To change the atomizing
head simply depress release buttons and pull the
atomizing head away from the spray gun body. Make
sure fluid needle is clean when replacing the atomizing
head. Then follow "Attaching the Atomizing Head"
procedure for connecting atomizing head.
Attaching Air Fitting
or Regulating Equipment
It will be necessary to connect an air fitting, an air
regulator or air flow control valve to the air inlet
located at the base of the spray gun body.
Note: Do not use the spray gun body to tighten the
connection with air flow control valve.
Note: When used with flammable materials this device
must be grounded. A test for adequate grounding should
be performed regularly.
8 8
Tabla de contenido
loading

Este manual también es adecuado para:

16587

Tabla de contenido