General Set Up And Spray Gun Use - 3M 05 Serie Manual Del Usuario

Contents
Unpacking
Remove the components from the box. Inspect for concealed damage and/or missing
items. If you discover any damage and/or missing pieces, contact your distributor
immediately.
Your 3M™ Series 05-100, 05-300 Spray Gun Kit includes:
• 3M™ Series 05 Spray Gun
• Cup
• Care Kit
3M™ Series 05-100 Primer Spray Gun
The 3M™ Series 05-100 Primer Spray Gun has an anodized
aluminum body construction, 10 cfm air consumption, 4.3:1
reduction ratio, 1/4" air inlet connection and a 43 psi maximum
inlet pressure*. This spray gun is for use with compressed air
systems only and is economically priced for automotive primers
and light general purpose use.
3M™ Series 05-300 Detail Spray Gun
The 3M™ Series 05-300 Detail Spray Gun has a chrome-plated
aluminum body construction, 3.5 cfm air consumption, 4.3:1
reduction ratio, 1/4" air inlet connection and a 43 psi maximum
inlet pressure*. This spray gun is for use with compressed air
systems only and is economically priced for automotive detail and
light general purpose touch-ups.
*Maximum inlet pressure will yield approximately 10 psi at the air cap.
7

General Set Up and Spray Gun Use

For additional instructions refer to your cup or fluid source manual.
Note: Flush the spray gun before using
Air Regulation
The 3M™ Series 05-100 Spray Gun
and the 3M™ Series 05-300 Detail
Spray Gun packages both include air
regulators. 3M™ Series 05-100 Spray
Gun has an external detachable regulator
while the 3M™ Series 05-300 Detail
Spray Gun has an internal regulator.
The regulator adjustment knob on the
3M™ Series 05-300 Detail Spray Gun
is located at the base of the spray gun
handle directly next to the air inlet.
Counter-clockwise adjusting will increase
airflow, while adjusting clockwise will
decrease airflow on either spray gun.
Adjusting Fluid Flow
The fluid flow can be adjusted by using
the needle adjustment screw as noted in
Fig. 1. As a starting point, gently turn the
knob clockwise until you have very little
needle travel (pull trigger to verify). Do
not over-tighten. After the needle travel
has stopped, further tightening will only
serve to compress the spring and will
not aid in adjustment. Next turn the
knob counter-clockwise two full turns.
These adjustment procedures will serve
only as a starting point. Fine tuning of
these adjustments will be based on your
material and technique.
Needle Adjustment Screw
Fig. 1
3
8