3M 07 Manual Del Usuario página 13

Spray Gun Care and Cleaning cont.
9. With the spray gun pointed down,
clean the front of the spray gun,
using a soft-bristle brush and
solvent.
10. Scrub the retaining ring, air cap and
fluid nozzle with a soft-bristle brush.
To clean out air cap holes, use a
small brush. Clean the air cap and
fluid nozzle after each use. Do not
soak the retaining ring in solvent for
prolonged periods of time.
11. Thread fluid needle tip on finger
tight. Pull trigger back and hold
while you install the fluid nozzle with
the gun wrench. Tighten the nozzle
securely to obtain a good seal.
12. Install the retaining ring and air cap.
13. Dampen a soft cloth with solvent
and wring-out the excess. Point
the spray gun down and wipe off
the outside of the spray gun.
12
3