Produktgruppe 512
45 von 46
Register the liquid dispensing module:
Service mode
Main menu
module?
OK button
Switch on dispensing display.
Service mode
Main menu
OK button
Back button (go back one level)
Note
Through the switched-on dispensing display the user can select/deselect dispensing. When the display
is switched off, the user can only view if dispensing is on for the current program and how much is
dispensed.
Switch the machine off to exit service mode.
Connect dispensing pumps as per wiring diagram and calibrate:
If the flow rate of the dispensing pumps is known, enter this value directly in programming mode
(e.g., dispensing pump 1).
Programming mode
No
.....mL/min
OK button
If the flow rate of the dispensing pumps is not known, calibrate the dispensing pumps in programming
mode (e.g., dispensing pump 1).
Programming mode
Insert the dispensing pump intake hose into a container with a fill mark.
Fill the container to the fill mark.
Press the 0/1 button (dispensing pump runs for 60 seconds).
Use a beaker to refill the container to the fill mark.
Check the dispensed amount in the beaker and record in the display (V:.....mL).
Diskette symbol to save the dispensed amount.
Register an empty status message (e.g., dispensing pump 1).
Programming mode
No
Yes
OK button
Check dispensing in each program and adjust settings as necessary.
Perform a function check.
Back up data via service mode.
Service mode
Main menu
symbol to overwrite EW data.
Switch off the machine to exit service mode.
Finish up:
Check all water connections for leaks.
Re-install the chassis lid, the lid on the water side, the liquid dispensing cover and the connection box
cover.
Perform an electrical safety check.
Reconnect the machine to the power supply.
am
09.06.2010
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Service settings
Diskette symbol to save the registration.
Service settings
Main menu
Settings
Back button (go back one level)
Main menu
Settings
Main menu
Settings
Back button (go back one level)
Backup
Backup data for EW
Umbau- und Montageanweisung
Module registration
EZL with coding 1
Basic settings
Dispensing
Diskette symbol to save.
Dispensing flow rate
Dispensing pump 1:
Diskette symbol to save the flow rate.
Calibrate dispensing
Dispensing pump 1
Empty message for dispensing
Diskette symbol to save empty message.
Overwrite existing data?
M.-Nr. 07503821
Register
Dispensing: No
Yes
Dispensing pump 1:
Diskette
