EMAK Oleo-Mac OM 106 Manual De Uso página 47

Ocultar thumbs Ver también para Oleo-Mac OM 106:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 243
5.5.2 STOPPING TRAVEL
The forward/reverse travel of the machine is stopped by gradually taking your foot off the travel pedal and subsequently
stepping on the brake pedal.
In the event that cruise control is engaged and the brake pedal is stepped on, it automatically moves to the neutral position. The
braking distance is shorter than 2 m.
5.5.3 TRAVELLING SPEED AND MOWING GRASS
} It generally applies that the wetter, higher and more dense the grass is, the lower the travelling speed that should be used.
When the machine is travelling at high speed or when under large load, the rotation speed of the blades is reduced, the quality of
the cut is worse and the ejection chute may become clogged. Under such conditions always set the engine to maximum power.
} If the grass is very high, it is necessary to mow it several times. First mow at maximum elevation and with narrower mowing
coverage width if necessary. The second run can then proceed at the required mowing height.
} In the event that the 110 cm mowing deck is used for mulching, it is necessary to very carefully adjust the speed to the height
of the mulched vegetation respecting the significant load that this can place on the engine in this mode! The higher the grass,
the lower the travelling speed.
} We recommend mowing in the parallel or cross direction. Covering the previous coverage of the machine increases the
effectiveness of the blades and will improve the appearance of the mowed area.
} When travelling over uneven terrain the travelling speed may fluctuate.
Recommended travelling speeds of the machine based on conditions:
Condition of vegetation
High, dense and wet
Average conditions
Low, dry vegetation
Travelling without the mowing deck engaged
5.5.4 TRAVELLING ON A SLOPE
The 106 - 124 riding mower may work on slopes with an incline of up to 12°
(21%).
When working on a slope it is necessary to adhere to the following
fundamentals:
} Pay increased attention when travelling on a slope.
} Always use a slower travelling speed.
} Only travel perpendicular to the contour, i.e. up and down. Travelling in the
direction of the contour is possible with extra attention only when turning
the machine. If at all possible, avoid travelling along the contour.
} When turning ensure that a wheel does not drive over an elevated obstacle
(rock, tree root, etc.)
} Travel slower when travelling down a slope or over obstacles. Pay special
attention when turning and turning around on slopes.
} If you stop on a slope, always use the parking brake.
When overloading the machine by travelling on slopes over 12° (21%) there is a risk of serious damage to the gear box. The
manufacturer is not responsible for damage caused in this way.
Recommended speed
47
2 km/hour
3 – 5 km/hour
< 5 km/hour
< 8 km/hour
Right
Max 12
Wrong
P
o
(21 )
%
Tabla de contenido
loading

Este manual también es adecuado para:

Oleo-mac om 124Efco ef 106Efco ef 124

Tabla de contenido