Selecting Saw Blades - Delta UniSAW 36-L336 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

that the anti-kickback assembly is functioning.

ALIGNING RIVING KNIFE TO BLADE

1. Remove the throat plate, blade guard and anti-

kickback assemblies.

2. Raise the blade to full depth of cut and 0° bevel angle.

3. Raise the riving knife (J) Fig. 33 to the through-cutting

or highest position (Fig. 27).

4. Locate the three small set screws (PP) and (QQ)

adjacent to the riving knife locking plate (RR). These

screws will be used to adjust the riving knife position.

5. Lay a straight edge on the table against blade body

and make sure it extends out along the riving knife, as

shown in Fig. 32. The riving knife should just touch the

straight edge. If adjustment needed, loosen the two

socket head cap screws (SS) Fig. 35.

6. Adjust the set screws (PP) and (QQ) Fig. 33 to move

the riving knife in line with the blade according to

the position noted in STEP 5. Lay the straight edge

on the opposite side of the blade and repeat these

adjustments as needed.

NOTE: The two set screws (PP) near the riving knife

locking plate (RR) adjust the riving knife as shown from

the TOP VIEW (Fig. 36). The set screw (QQ) adjusts the

riving knife as shown from the BACK OF TABLE VIEW

(Fig. 37).

7. Lightly tighten the two socket head cap screws

(SS) Fig. 35.

8. Place a square flat against the riving knife and verify

riving knife is vertical and in-line with the blade.

(Fig. 34)

9. If needed, use the set screws to bring the riving knife

vertical with the square.

10. Repeat STEPS 5 and 6 to verify position of riving knife.

11. Fully tighten the two socket head cap screws (SS)

Fig. 35.

12. Replace throat plate before use.