Maintenance; General; Daily Maintenance; Cleaning - Husqvarna DM650 Manual De Instrucciones

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
Shut down the machine and disconnect
the power plug.
Wear personal protective equipment. See
instructions under the "Personal
protective equipment" heading.
The life span of the machine can be reduced and the risk
of accidents can increase if machine maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest service workshop.

Daily maintenance

• Check that the machine's safety equipment is
undamaged. See instructions in the section
"Machine's safety equipment".
• Check that the cable and connector are intact, clean
and in good condition.
• Clean the outside of the machine.

Cleaning

• Keep the machine and drill bit clean in order for drilling
to be carried out safely.
• Use a brush and a damp cloth to clean the drill.
CAUTION! Do not use a high pressure washer to clean
the machine. The high pressure jet can damage seals
and lead to water and dirt permeating into the machine,
resulting in serious damage.

Water tap

Check that the water tap functions. Do not use hoses that
are distorted, worn or damaged.

Electrical Feed

WARNING! Never use damaged cables.
!
They can cause serious, even fatal,
personal injuries.
14 – English

MAINTENANCE

Changing the gearbox oil

The oil in the gearbox must be changed after every 300
hours of operation.
• Unscrew the oil plug.
• Empty the oil into a container. Handle oil carefully of
environmental considerations. Follow local recycling
requirements.
If necessary contact your dealer to clean the gearbox.
• Pour the new oil into the gearbox, 1 litres. Refer to
Technical Data for recommendations on which oil type
to use.
• The oil plug is fitted with a magnet that captures metal
particles. Wipe the oil plug clean and screw it back.