Charger Wall Mount; Settings; Adjusting Torque; Tool Holder, Attachments - Festool CXS Manual De Instrucciones Original

English
klick
1
4-1
2
7.4

Charger wall mount

The charger MXC has two elongated holes on
its back. It can be mounted on a wall using two
screws (e.g. round head or flat head screw with
shank diameter of 5 mm) (see Fig. [5]).
5
3 mm
85 mm
(3
8

Settings

Consider the pictures on the fold-out page.
12
1
4-2
11 32 '')
4
Risk of injury
► Always switch off the power tool before ad­
justing settings!
8.1 Changing direction of rotation [1-5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rota­
tion
8.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
8.3

Adjusting torque

By turning the torque thumbwheel [1-2] the re­
quired torque can be adjusted. The arrow [1-3]
aligns with the adjusted state.
Drilling
Turn the torque thumbwheel [1-2] so that its
marking [1-3] faces the drilling symbol [1-1].
Maximum torque is set in this position.
Fastening
Adjust the torque accordingly at the torque
thumbwheel [1-2]:
Position 1 = low torque
4-3
Position 12 = high torque
The machine switches off when the present tor­
que is reached. The machine only continues
running when the on/off switch [1-6] is re­
leased and pressed again.
9

Tool holder, attachments

Risk of injury
► Always disconnect the battery pack before
performing any type of work on the ma­
chine!
Hot and sharp tools
Risk of injury
► Do not use insert tools that are blunt or de­
fective.
► Wear protective gloves.
9.1 Tool chuck CENTROTEC WH-CE
The tool chuck CENTROTEC WH-CE allows you
to change tools with a CENTROTEC shank in a
matter of seconds.
CAUTION
WARNING
CAUTION