Operation; To Fill Fuel; To Adjust The Seat; To Release And Apply The Hydraulic Pressure - Husqvarna P 524 Manual De Usuario

9. Open the equipment frame lock.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.

To fill fuel

WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 13 ).
WARNING: Do not use the fuel tank as a
support area.
The engine runs on unleaded gasoline with a minimum
octane rating of 95 (not mixed with oil). We recommend
biodegradable alkylate gasoline (max. methanol 5%,
max. ethanol 10%, max. MTBE 15%).
Do a check of the fuel level before each use and refuel if
necessary.
You can clearly see the fuel level in the fuel tank. Do not
fill too much. Keep a minimum space of 2.5 cm.

To adjust the seat

WARNING: Do not adjust the seat during
operation of the product.
The seat can be tilted forward. It can also be adjusted
forward and rearward.
16
10. Hold the front edge of the cutting deck with 2 hands
and pull it out.

Operation

• To adjust the seat forward and rearward, push the
lever below the front edge of the seat to the left.
Move the seat to the required position.
Fuel safety
• To adjust the seat springs, move the rubber stops
below the seat as given in the illustration. Put the 2
stops in the front, middle or rear.
To release and apply the hydraulic
pressure
To move the product with the engine off, you must
release the hydraulic pressure. The hydraulic pressure
is released and applied with a bypass valve.
CAUTION: Close the 2 bypass valves before
you operate the product. If they are open, the transmission can become damaged.
242 - 003 -