Operation; Husqvarna Connect - Husqvarna S 138i Manual De Usuario

5. Tighten the knobs fully.
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 33)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
Introduction
WARNING:
product, you must read and understand the
safety chapter.

Husqvarna Connect

Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the work depth
WARNING:
depth when you operate the product.
1. Push and turn the adjustment knob for the work
depth counterclockwise to increase the work depth.
2. Push and turn the adjustment knob for the work
depth clockwise to decrease the work depth. (Fig.
37)
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
20

Operation

Before you operate the
Do not adjust the work
Before you use the battery,
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 34)
4. Lift the rear cover.
5. Move the grass catcher into the correct position.
(Fig. 35)
6. Attach the grass catcher to the top edge of the
chassis. Make sure that the rear cover seals against
the grass catcher to prevent leakage. (Fig. 36)
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
Battery on page 23 .
See
(Fig. 38)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are
lit
LED 1, LED 2 are lit
LED 1 is lit
LED 1 flashes
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
Note:
The battery charger must be connected to the
voltage and frequency specified on the rating plate.
The battery does not charge if the battery temperature
is above 50°C. The battery charger decreases the
temperature of the battery before it starts to charge.
1. Connect one end of the power cord for the battery
charger into the socket of the battery charger.
2. Connect the other end of the power cord for the
battery charger in an grounded mains socket. The
LED on the battery charger flashes green one time.
(Fig. 39)
3. Put the battery in the battery charger. The green
light on the charger comes on when the battery is
correctly connected to the battery charger. (Fig. 40)
4. When all LEDs on the battery have come on the
battery is fully charged. Charge the battery for
maximum 24 hours.
5. To disconnect the battery charger from the mains
socket, pull the plug, not the power cord.
Battery status
Fully charged (75-100%)
The battery is 50%-75%
charged
The battery is 25%-50%
charged
The battery is 0%-25%
charged.
The battery is empty.
Charge the battery.
937 - 006 - 05.10.2022